View Single Post
Old Dec 06, 2012, 03:04 PM
projectDemon is offline
Find More Posts by projectDemon
Registered User
projectDemon's Avatar
Joined Jun 2012
19 Posts
Hello,

we from projectDemon built a new copter. This is the first time we used a CAD program, so hopefully you like it. The material is carbon (centerplate: 1.5mm, sticks (or what word is used in english for it?): 3mm x 3cm).
We didn't test this new copter yet, but will do it on weekend.

The specifications:

Suppo A2212/13
Turnigy Plush 18A
MultiWii 2.1
Drotek 10DOF
9 inch propeller

How do you find it? (the third picture is a comparison with our old copter (emax Gf2210, Turnigy Plush 12A, MultiWii, Drotek 10DOF, LZ GPS 2.1, 8" props)

Regards,
projectDemon
projectDemon is offline Find More Posts by projectDemon
Last edited by projectDemon; Dec 06, 2012 at 03:25 PM.
Reply With Quote