View Single Post
Old Dec 05, 2012, 10:49 PM
Sudsy is offline
Find More Posts by Sudsy
It's Just a Hobby!
Sudsy's Avatar
Joined May 2012
1,205 Posts
Quote:
Originally Posted by RC_Kid View Post
Thank you SO much. Just moving the trim lower, let it arm. I guess it needs to be below the 0% mark on the RX test to arm. I will add some travel to my EPA.

Thank you again!

It took me a long time to figure out that I could "safe" the board buy moving the stick full left at idle. That keeps it from jumping up in your face when you bump the throttle when picking it up after a flight.

Check "Failsafe" settings too. It's a terrible thing to watch your new quad sail off into the blue! I set mine to just above hover so in theory it will make a slow decent when the batts start going low!

Sudsy
Sudsy is offline Find More Posts by Sudsy
Reply With Quote