View Single Post
Old Dec 05, 2012, 10:45 PM
RC_Kid is offline
Find More Posts by RC_Kid
Registered Crasher
United States, NJ, Lincoln Park
Joined Apr 2005
106 Posts
Originally Posted by Sudsy View Post
Ok I just got my tx.

I am looking at one of my quads setup and all of them are set the same for throttle and arm/disarm work fine.

Leave the default on the KK2 for min throttle at 10.

In menu look at "travel adjust".

Select throttle channel.


H 150%
L 100%
trim to minimum.

Let me know if this works for you.


Thank you SO much. Just moving the trim lower, let it arm. I guess it needs to be below the 0% mark on the RX test to arm. I will add some travel to my EPA.

Thank you again!
RC_Kid is offline Find More Posts by RC_Kid
Reply With Quote