View Single Post
Old Dec 05, 2012, 09:32 PM
SteveT. is online now
Find More Posts by SteveT.
I fly, therefore, I crash!!!
SteveT.'s Avatar
San Jose, CA
Joined Jan 2008
31,964 Posts
The best temp to apply Ultracote is about 240-280 degrees, and maximum shrinkage occurs at around 350 degrees. If you get bubbles, use a needle or small sharp pin to pierce the bubble and iron it down. the hole will not be seen...

If trying to use a home iron, set it on the setting for cotton.

SteveT
SteveT. is online now Find More Posts by SteveT.
RCG Plus Member
Latest blog entry: My hangar...
Reply With Quote