View Single Post
Old Dec 05, 2012, 07:34 AM
x5252x is offline
Find More Posts by x5252x
Registered User
Joined Jun 2010
37 Posts
Quote:
Originally Posted by flybyjohn View Post
will this work if you have an airplane tx. I want to use this application on a micro airplane but the voltage only goes from zero to full volts in half the stick movement. I need for the voltage to be at zero when the stick is all the way down and at full voltage when the stick is all the way up. Does any body know how to do this?
I'd try connecting this up with the pot on, leaving the stick at the bottom, then rotating the pot so that the servo board gives out 0v, then check the max voltage by moving the stick all the way up, then adjust the end point so that when the stick is pushed all the way up, it gives out slightly below the max voltage, then increase the end point by a very small amount so it will give the max. That should provide you with what you need.
x5252x is offline Find More Posts by x5252x
Reply With Quote