Thread: Discussion Fairwind III by Kyosho
View Single Post
Old Dec 04, 2012, 02:16 PM
lilleyen is offline
Find More Posts by lilleyen
Still showing up for breakfast
lilleyen's Avatar
Ontario Canada
Joined Mar 2009
1,106 Posts
Quote:
Originally Posted by Boomer1 View Post
Thanks for that information. The vang I have is about 175mm long - I am thinking I can make it work by locating the back attachment point further aft on the boom. Playing around with that today to see if the geometry works out. Posted a few pictures that give you the general idea of how it might look in place. I can always cut the rod to a better length and re-thread it. It should work out ok. I like the look of this vang on the boat, so I guess that means I have to make fit.

I was looking for a pulley for the sheet line to replace the factories devise and found the item below at this link: http://www.ebay.com/itm/Single-10mm-...item337d13fd98


The Block is 10mm wide x 15mm long , 2mm Wide at the bracket
Swivel post is 8mm long, 1.5mm diameter and the deck spacer is 1mm High

Price is $16.00 USD free shipping -

The clip thingy in the boat is about 20mm long overal - hard to get my micrometer inside there. But this one should fit.
Serenity Vang looks good, does it clear your railings full out?
Thanks for the link.
I have a home made pulley I may use, if not, that one will do fine.
lilleyen is offline Find More Posts by lilleyen
Reply With Quote