View Single Post
Old Dec 04, 2012, 01:45 PM
v8truckin is offline
Find More Posts by v8truckin
Should've, Would've, Could've
v8truckin's Avatar
United States, CA
Joined Dec 2010
7,295 Posts
If you have no slop then grind the flat spot that sits in the trunnion. If you do it on the oleo to 5mm pin it'll only cause you problems if not done right and the no slop will turn into slop. However on the trunnion flat spots you have 2 of em and wanna make sure you get those right. Pick your poison.
v8truckin is offline Find More Posts by v8truckin
Reply With Quote