Thread: Discussion V-Bar Firmware update
View Single Post
Old Dec 04, 2012, 01:16 PM
nwmtech is offline
Find More Posts by nwmtech
RC Heli Nation
Bellingham, WA
Joined Aug 2009
5 Posts
Quote:
Originally Posted by neoalchemist74 View Post
My problem is in setting the end points. I cant get any response from the esc if I attempt to set them with the throttle lead through the SK540( I dont have this problem when setting up the throttle normally, without governor turned on.) and if I attempt to set the end points out side of the SK first through the reciever it works unttil I unplug the esc then plug it back in, then the esc will not arm. I got it to work with the esc in airplane mode but its glitchy and it does"t feel like the rpm is correct. So its back to the CC governor for now.
This is actually a SK glitch that will be fixed with the next firmware. There is a way around it described here http://www.rchelination.com/sk540-governor-with-cc-esc/ The performance on the SK Gov is quite worth it over the CC gov. The update will allow use of either the SK softstart and bailout or the CC soft start and bailout btw
nwmtech is offline Find More Posts by nwmtech
Last edited by nwmtech; Dec 04, 2012 at 01:23 PM.
Reply With Quote