Thread: Help! Enforcer Gas Boat
View Single Post
Old Dec 03, 2012, 05:27 PM
txt killer is offline
Find More Posts by txt killer
Registered User
Joined Apr 2008
1,018 Posts
Quote:
Originally Posted by dsawyer44 View Post
I'm trying to convert my drive system to a cable that is square at both ends. I quess i need a shaft that has a female square. I have to extend my rudder assy because there isn't enough room for a coupling.
WHAT? The furrel side isn'nt square it is round for a 3/16"shaft or 1/4" shaft. I asked because the motor you have I would use the 3/16" shaft because you have more prop options. You need more than just a flex shaft and brass furrel to complete the change over. You cut the cable to length you need and silver solder on the brass furrel. The brass furrel has set screws to hold the end of the prop shaft and flex cable together.
txt killer is offline Find More Posts by txt killer
Reply With Quote