View Single Post
Old Dec 03, 2012, 08:57 AM
Del-Dredd is offline
Find More Posts by Del-Dredd
Registered User
Del-Dredd's Avatar
Near Aberystwyth - Wales
Joined Aug 2004
2,135 Posts
Have you got ESC power supplied to board from ESC 2 or 3, the servo needs power on M2 - M8 which are ganged for its supply.
If you only have ESC1 powering board, that is your problem.

It states that on Post 1 FAQ.

It also will not move until you have raised throttle a bit.
Del-Dredd is offline Find More Posts by Del-Dredd
Reply With Quote