Thread: Discussion Thoughts on eflite leader 480
View Single Post
Old Dec 03, 2012, 03:42 AM
CSI is offline
CSI
Find More Posts by CSI
CSI
I promise, just ONE more order
CSI's Avatar
Del Rio Intl, Texas, United States
Joined Feb 2004
4,024 Posts
Thanks for the additional comments guys. I spent the evening with my covering iron going over all the parts, removing wrinkles, making sure seams were down tight, etc. The red and blue covering is pretty tough to work on...stubborn!

I also had to glue one of the wing tabs back into place. Found it down inside the wing?! I "cleaned" out the landing gear channels and mounted the gear nice and flush. I also mounted the servos...regular MG90s. I have had pretty good service from these little metal gear guys. Looks like the factory mounted up the nosegear bracket at an angle, so will have to straighten that out tomorrow. Just taking my time, checking out everything as I go along. Fun build so far.
I also added some thin pinstripe to the edges of the red and blue trim just to give it some more definition. I did this on my MUS and it came out well, so thought I would try it here. So far it's looking nice.
Thanks again guys,
Ken
CSI is offline Find More Posts by CSI
RCG Plus Member
Reply With Quote