View Single Post
Old Dec 02, 2012, 09:32 PM
ridge_racer is offline
Find More Posts by ridge_racer
Registered User
United States, NY, New York
Joined Nov 2010
2,630 Posts
Had a blast flying my 500esp like I do on the sim today. Finally started inverted circuits and inverted piros etc. I was in the middle of an on axis roll when bam........the tip weight blew out of one of my blades. Second time this has happened with a set of Target Hobbies carbon blades. I have the HB3650 1700Kv motor on 6s with a 13t pinion. idle up 1 throttle curve is 95,90,90,90,95. I think the YEP80 esc is looking at anything 90 and above is =100 throttle. I notice an rpm increase from 85-90 when going from normal to idle up at mid stick. My first 500 build guys so please don't kill me. What should I be shooting for in regards to head speed for great power in 3d? I'm think I should just lower idle up across the board by 5% or lower mid stick only by 5%.
ridge_racer is offline Find More Posts by ridge_racer
Reply With Quote