View Single Post
Old Dec 02, 2012, 02:06 PM
KamikazePilot is offline
Find More Posts by KamikazePilot
Twisted Do Nut!
KamikazePilot's Avatar
United States, TX, San Antonio
Joined Dec 2010
2,734 Posts
After I put a bead down, I go over it with a razor blade or old plastic card. Just a small amount is needed. Here's another tip for you guys. The sfg's on my planes were getting worn so I started to use the same thing on them. Some welders gone over with a razor blade still flexible but more sturdy for the times where they might see some wear.
KamikazePilot is offline Find More Posts by KamikazePilot
Reply With Quote