Thread: Discussion Walkera DEVO Tx Hacking
View Single Post
Old Dec 02, 2012, 06:34 AM
Tripert is offline
Find More Posts by Tripert
Registered User
Spain, Asturias
Joined May 2012
36 Posts
I have extracted the "standoff". First you need to retire the screws. There is one that you can't retire because it seems to be inverted. It seems like it arrives from the front of the transmitter, but I have been unable to find how to access to the head of this screw.

Well, when you have all the screws removed (minus the screw that is inverted). Then with the finger press the transparent plastic with some force until it separates from the "standoff" (it is not necessary to full retire it, only at the borders of the "standoff"). After that, the "standoff" is able to separate from the body . With a screwdriver, force the "standoff" at the place of the screw that is inverted till the "standoff" get out. Be aware to try to don't mark the transparent plastic or break the "standoff". You need to make force to extract the "standoff" from the screw. Be aware because the "standoff" could break. I got mine out, without problem but you need to be careful to get it out.
Tripert is offline Find More Posts by Tripert
Last edited by Tripert; Dec 02, 2012 at 08:25 AM.
Reply With Quote