Thread: Discussion Walkera DEVO Tx Hacking
View Single Post
Old Dec 01, 2012, 11:25 PM
PhracturedBlue is offline
Find More Posts by PhracturedBlue
Registered User
Joined Jan 2012
682 Posts
I got a 2.4" screen today (but not yet the development board). While it is smaller than the opening in the Devo7, I think it'll work ok. Has anyone ever figured out if it is possible to fully disassemble a Devo7 (or WK2601/2801/Devo10) and separate the bezel? There is a standoff behind the plastic (where the screen goes) that appears to be held on with 6 screws. 5 of them are accessible from the back, but one appears to be driven from the front underneath the bezel. I think the bezel is fused to the transmitter body; at least I haven't yet figured out a way to fully disassemble it and remove the standoff. I may end up cutting it out, but I thought I'd check if anyone has any insight.
PhracturedBlue is offline Find More Posts by PhracturedBlue
Reply With Quote