View Single Post
Old Nov 30, 2012, 01:51 PM
ultimatetwo is offline
Find More Posts by ultimatetwo
Fly to live- Live to fly
ultimatetwo's Avatar
ROTA-CADIZ-SPAIN
Joined Jan 2008
1,249 Posts
so... let´s go with the tail surfaces... After both sides were fine sanded, we finish the elevators on a sharpie trailing edge, but leaved over 2mm. on the end to avoid any warping when covering...
After that we traced the optionals lightening round holes, caution was used so these holes doesn´t will be too close were´re the hinges...:
And that´s all by now folks...have a good weekend...popcorn:
ultimatetwo is offline Find More Posts by ultimatetwo
Reply With Quote