Thread: New Product GW Xieda 9958
View Single Post
Old Nov 30, 2012, 09:38 AM
siriusflier is offline
Find More Posts by siriusflier
siriusflier's Avatar
United States, TX, Wilbarger
Joined Apr 2012
3,703 Posts
xypher, I had a tiny piece of grit get into one of my servo's gears that caused it to stick-I could not see it and it was hard to get out, but it finally started working right again. Check your tail motor mount, make sure it has not been moved forward by a crash, inspect your wires carefully, make sure none are broken, stripped or shorted together, and check the motor wires and theservos where they mount to the board to make sure they are soldered properly. Make sure your rudder trim on the transmitter is centered, when you move it it will beep, makes a different beep when you hit center. It may be a problem with the board, but you need to very carefully check all other possibilities first. I have to use reading glasses and a jeweler's loop to really be able to see details on the tiny wires and connections.
siriusflier is offline Find More Posts by siriusflier
Reply With Quote