View Single Post
Old Nov 30, 2012, 12:54 AM
Andre6553 is offline
Find More Posts by Andre6553
Vulcan skyhook multirotor
Andre6553's Avatar
South Africa, GP, Pretoria
Joined Feb 2011
665 Posts
Quote:
Originally Posted by archet View Post
I remembered that the only noticeable operation I did after the gimbal stabilization was working, was taking off all the power wiring from the ESC connections to the FC. I did it because everywhere I have read advices to take off the power wires from the ESCs if the FC is already powered separately.
Because I couldn't find any solution to the problem I just tried to reconnect the power wire of only one ESC and suddenly the pitch and roll servos started working again.
Anyway, the roll servo put the gimbal all the way on one side while the pitch servo positioned the camera plate in a correct position horizontally.
I connected again other ESC's power wires to the FC, but the roll stabilization doesn't want to work at all, while the pitch stabilization works normally and I can control it manually from channel 7 of Tx.
Any suggestion about the roll stabilization problem?
Thanks
Do you have a bec power your servos and only run the signal wire to the flight controller.
You must not connect the power wires from the esc!
Andre6553 is offline Find More Posts by Andre6553
Reply With Quote