View Single Post
Old Nov 29, 2012, 06:23 PM
PittSpecial is offline
Find More Posts by PittSpecial
Right Rudder
PittSpecial's Avatar
USA, FL, Orlando
Joined Nov 2010
10,545 Posts
Checking for Bad Servos and Control Linkages / Push Rods etc...

Guys,

I highly recommend to check the AMP draw of the combined servo duty current draw and look out for higher than normal AMP draws. This is useful to detect a servo going bad and as in my case a Push Rod with a sleeve getting hung on the wire! All of which has the potential in losing your model (Crash).

I will be using my Watt Meter.
PittSpecial is offline Find More Posts by PittSpecial
RCG Plus Member