View Single Post
Old Nov 29, 2012, 06:04 PM
PittSpecial is offline
Find More Posts by PittSpecial
Right Rudder
PittSpecial's Avatar
USA, FL, Orlando
Joined Nov 2010
10,554 Posts
Quote:
Originally Posted by PittSpecial View Post
I wish it was my battery! Nope, I am using new Turnigy 3-Cell, 2200mAH, 25C, Li-POLYs and they put out the power. I am uploading a video showing the bearing noise at the lower throttle. Last night I took off the motor from the model and tried without any success to take apart the motor. The round keeper at the end bell could not be taken off due to the set screw in permanently and I guess they used the wrong type of Loc Tite at the factory!!

Needless to say, I went ahead and sprayed the motor with CRC 2-26 solution and cleaned out the motor as much as possible without taking apart the motor and used some RevDrops (In the days of lubricating Brushed Motors and their bearings) and still the Stock Park Zone 480 exhibits bearing noise at low RPM.

I guess the motor is coming out.
Here is the VIDEO!!!!!!!
Park Zone Stock 480 Brushless Motor Bearing noise at low RPM 11-27-2012 (4 min 1 sec)
PittSpecial is offline Find More Posts by PittSpecial
RCG Plus Member