View Single Post
Old Nov 29, 2012, 10:01 AM
Bill Mercer is offline
Find More Posts by Bill Mercer
Registered User
Joined Oct 2011
41 Posts
Well, on looking it over again last night the wires were right at the edge of the area that needed gluing, so I just glued the tear very carefully, then set the thing on some scrap balsa to hold the dihedral while it dried. Seems to have worked out alright--the wire appears to be free, and the plane is back to two wings.

Now I'm wondering if I should make run a couple thin carbon-fibre rods across the damaged area to make sure everything stays together.
Bill Mercer is offline Find More Posts by Bill Mercer
Reply With Quote