View Single Post
Old Nov 28, 2012, 11:41 PM
SkyCadet is offline
Find More Posts by SkyCadet
Segelfliegen bedeutet Freiheit
SkyCadet's Avatar
Canada, MB, Winnipeg
Joined May 2010
1,083 Posts
Servos installed, RX tray and fuselage innersides done!

I finished installing the servos, into both the wings and tail. Ran a 12" extension on the servos in the tail, and will be using HK servo wire clips on the wings so that a Y harness can affix the wing servo connections.

Also paint-tinted the outer fuselage front and epoxied the RX tray onto the rear runner behind the battery tray.

I used CF rod/1" balsa blocks on the mains for reinforcement, pictures shown below... Now, just motor, setting the horn throws, and then connecting the electronics!

Sky Cadet
SkyCadet is offline Find More Posts by SkyCadet
RCG Plus Member
Latest blog entry: New plane - Evader!!!
Reply With Quote