Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Nov 28, 2012, 08:29 PM
tom-tom 1 is offline
Find More Posts by tom-tom 1
Registered User
Joined Jun 2010
61 Posts
Quote:
Originally Posted by foam and tape View Post
It's back in this thread somewhere, i'll see if I can find it. The rear surfaces are setup as elevons for redundancy (I did accidentally bump the front elevator loose once and it continued to fly) I didin't tweak the code to control any of the flight control surfaces, I just Y harnessed them to the standard 4 CH controls.
I have the code from this thread. I assume the last code posted is the one you used. It's the 1.7 code for the QTR.
So you did't use pin# A0-A1-A2 for your TILT-LEFT AILERON-RIGHT AILERON?
and you did plug your tilt-R aileron-L aileron straight into your receiver?
tom-tom 1 is offline Find More Posts by tom-tom 1
Reply With Quote