View Single Post
Old Nov 28, 2012, 04:56 PM
Socratic is offline
Find More Posts by Socratic
Registered User
United States, NH, Barrington
Joined Sep 2011
249 Posts
Quote:
Originally Posted by Mr_westie View Post
Socratic, they may not start at the same time depending on jow level the craft is.
To test if calibration is successful, put it back into "Init setup".
That is the only time it send the the same signal to all motors.
Do not fly in this mode.


elossam,
Use , Black, Yellow White

Ground, +5v , Cur AD
Just gave it a few more tries. It does go into setup but I am not getting any confirmation beeps after I power esc's back on and reduce throttle to zero. I thought I had it working but then one of the motors cut out at half throttle. Yes, I hear you. Don't think I am about to fly until I work this out.
Socratic is offline Find More Posts by Socratic
Reply With Quote