Thread: Discussion HK250GT 6Ch from a DH9116
View Single Post
Old Nov 28, 2012, 04:03 PM
Balr14 is offline
Find More Posts by Balr14
Cranky old fart
Balr14's Avatar
Germantown, WI.
Joined Oct 2007
21,564 Posts
You are doing great! But, don't shift in to idle up mode on the ground. You want to be in the air at neutral throttle; much less stress on the equipment. You should probably get used to using throttle hold, rather than cutting the throttle in a crunch situation. When you cut throttle quickly you induce negative pitch, so you come down faster. There are two ways to offset this: use a pitch curve that has very little negative pitch or raise throttle trim. The downside of doing this is it reduces your ability to fight wind. But, if you use throttle trim, you can reduce it with a flick of a finger. The use of throttle trim to control flight characteristics is standard operating procedure on the Thunder Tiger Innovator. It works quite nicely on quads, too.
Balr14 is offline Find More Posts by Balr14
Reply With Quote