Thread: Discussion Multiplex Funjet Ultra
View Single Post
Old Nov 27, 2012, 08:33 PM
WhalleyB0Y is offline
Find More Posts by WhalleyB0Y
Registered User
WhalleyB0Y's Avatar
Canada, BC, Surrey
Joined Jul 2011
960 Posts
Hey guys I am totally new to whole FJU realm and I am currently having a problem with the spinner. Under load it seems the rotor pulls into the motor and the prop will strike the mount plate screws. The instructions are useless so I am asking if there is a correct way to install the motor, spinner and plate? I'd imagine I would need to find the right amount of clearance for setting the spinner but I don't think it should be hanging on the edge of the motor shaft. Any thoughts guys?
WhalleyB0Y is offline Find More Posts by WhalleyB0Y
Reply With Quote