Thread: Discussion OSD not level - any ideas?
View Single Post
Old Nov 27, 2012, 04:41 PM
S11D336B is offline
Find More Posts by S11D336B
S11D336B's Avatar
USA, FL, Winter Springs
Joined Apr 2006
3,066 Posts
The horizon may be cooked until you arm the multi-rotor.

Have you downloaded the new v4.6 setup client to go with the v4.6 firmware?

Are the accelerometer and temperature compensation check boxes checked in the "Pro Info" tab?

I'll check it out on my setup tonight to see if I can replicate the problem.

Thanks,
George

Quote:
Originally Posted by Efliernz View Post
I have not used the ODS in the past so I have nothing to compare this to.

I have flashed the latest firmware and started from the beginning with temp and the acc calibration process. I have done this twice, getting the same results. The horizon is not level... and it should be. It is level in the setup program.


Another thing I find strange is that I have centered all my TX trims and subtrims and started clean. My DW VM-6 (in manual mode) lifts up and is perfectly in trim. Magnificently perfect! When I switch to AL, I need a lot of roll trim to balance it - as though it is trying to balance to what the OSD tilt is. Yes I can trim it out (with a heap of trim), repower, all that stuff but I am wondering if others are seeing similar results when changing to the new firmware.

Pete
S11D336B is offline Find More Posts by S11D336B
Site Sponsor
Reply With Quote