Thread: Discussion MJX-F45 Single Rotor FP
View Single Post
Old Nov 27, 2012, 11:33 AM
rexless is offline
Find More Posts by rexless
Fly Fast, Fly Hard, Fly Fun
rexless's Avatar
Canada, BC
Joined Apr 2012
1,599 Posts
Quote:
Originally Posted by BThirsk View Post
Could someone do me a favour and measure the camera port outputs. I believe one is ground and one is 5 volts.
It is the signal that I am not sure of. What are the voltages and is it constant when the camera is enabled in the TX. I don't have the stock RX and am going to hook up to the 6 channel RX I am now using.
Looking at the left side by the camera connector, pins from left to right.
Camera off
Pin 1 negative Pin 2 positive voltage 4.95v
Pin 1 with Pin 3 shows -0.04v
Pin 2 positive Pin 3 negative voltage 5.00v

Camera on
Pin 1 negative Pin 2 positive voltage 1.68v
Pin 1 with Pin 3 shows 3.31v
Pin 2 positive Pin 3 negative voltage 5.00v

I'm not sure if I'm doing this correctly or not, but that's what I get.
rexless is offline Find More Posts by rexless
Reply With Quote