Thread: Help! Accu-Glo II Problem
View Single Post
Old Nov 26, 2012, 02:13 PM
Cougar429 is offline
Find More Posts by Cougar429
Registered User
Cougar429's Avatar
Canada, ON, Windsor
Joined Apr 2008
1,444 Posts
Both previous units showed a fixed output. The first had the center leg of the pot not soldered into the board and even with that corrected had a fixed volt and amp output to the plug. The lights would change from "COLD" to "HOT", but that is on a separate comparator.

The new panel had twice the volt and amp output, just barely enough to heat the wire. Again, adjusting the pot had no effect on output.

I to checked both against our lab power supply at work which monitors amp flow. That was how I confirmed there was no change in the current while a voltmeter on the plug gave me that reading.
Cougar429 is offline Find More Posts by Cougar429
Reply With Quote