Thread: New Product Swist
View Single Post
Old Nov 26, 2012, 01:29 PM
DownUnderPilot is offline
Find More Posts by DownUnderPilot
2012 NZ Speedcup - 231 MPH
DownUnderPilot's Avatar
New Zealand, Tasman, Richmond
Joined Mar 2006
2,281 Posts
A dremel flat would be fine, there's probably a better way, someone would have done a perfect flat for sure!

I had to cut about 8-10mm of the shaft on my 4020 so the spinner mated up agaist the bell, I guess it's fairly typical.
DownUnderPilot is offline Find More Posts by DownUnderPilot
Reply With Quote