Thread: Discussion GMFC Foam cutting software
View Single Post
Old Nov 26, 2012, 01:23 AM
Geoff_S is online now
Find More Posts by Geoff_S
Registered User
Geoff_S's Avatar
Brisbane, Australia
Joined Feb 2002
1,390 Posts
Sorry, forgive my stupidity, but where do I enter the second heat value - at the "min" speed ?? Does min speed need to be S/2 ??

The help file, under Foam Management, says also "Note that the kerf is always the same whatever the heat value" - I really don't understand what this is trying to say.

Perhaps I'm making this more difficult than it really is....
Geoff_S is online now Find More Posts by Geoff_S
Reply With Quote