View Single Post
Old Nov 25, 2012, 06:31 PM
RickEis is offline
Find More Posts by RickEis
Registered User
United States, AZ, Prescott Valley
Joined Feb 2012
179 Posts
Dennis,

Something happened to the gps.

In V2 I simply had to change the BAUD to 38400 and it would see the gps.

Beta2 would not see the gps until I did this also. Beta2, during delay sees the satellites. However, notice the elevation is wrong (should be 4581 ft) and then once the delay goes away everything goes to 0.0 ?
V2 did not do this - it appeared to work perfectly?

If you tell me where to change the alt and mah (move left 2 digits) for this silly monitor, I will for these picts I post here I agree - do nothing to your code because the alignment in my Dominator is perfect


Beta2 says:
#define VOLT_MEAS 0 // Battery voltage A0
#define CURRENT_MEAS 1 // Current sensor A1
#define RSSI_MEAS 2 // RSSI or second battery on A2

Is this right or the schematic ? Schematic shows A1 = RSSI I don't mind doing modifying the schematic

Is RSSI set to go?

I'll have to figure how to get the signal from a EzUHF Rx ? Anyone know how ? The Rx has three wires that connect to the OSD one red, yellow and white? What kind of volts should I be looking for etc.?

Rick
RickEis is offline Find More Posts by RickEis
Last edited by RickEis; Nov 25, 2012 at 06:50 PM.
Reply With Quote