Thread: Discussion GMFC Foam cutting software
View Single Post
Old Nov 25, 2012, 05:33 PM
Geoff_S is offline
Find More Posts by Geoff_S
Registered User
Geoff_S's Avatar
Brisbane, Australia
Joined Feb 2002
1,390 Posts
Quote:
Originally Posted by gm.cnc View Post
That depends if you are using the "computer controlled mode or not". In computer controlled mode, you also have to do calibration at a low speed so that GMFC has a line with the heat for differing speeds.
Maybe this is my problem - I am using computer-controlled heat, but can't see anywhere to put a second kerf measurement ?? Screen shot below is from my computer:
Geoff_S is offline Find More Posts by Geoff_S
Reply With Quote