Thread: Build Log MDC F-14 plans and pics
View Single Post
Old Nov 25, 2012, 11:01 AM
tripn4days is offline
Find More Posts by tripn4days
All Thumbs
Joined Jun 2012
137 Posts
Quote:
Originally Posted by rayonnair View Post
I'm not sure how your futaba radio is set up, but on the DX6i which is a 6 channel radio with only 2 position switches I set up a mix that did something like the following:

Code:
SW1:      OFF OFF ON
SW2:      OFF ON  ON
POSITION: 1   2    3
Thank you for the tip! I'm running an older Futaba 6XA and wound up running the wings off of the CH6 "trainer" switch/knob. I set the ATV b/t full open and full close and then use the dial to open anywhere inbetween. It works out really nice and allows for an "infinite" number of settings

Wing Sweep (0 min 25 sec)


Now how easy it will be to twist knob while in the air has yet to be seen. All I have left is to install rudders (which seem like the weakest point on this plane; I may try to re-engineer something) and attach the elevators and motor.
tripn4days is offline Find More Posts by tripn4days
Last edited by tripn4days; Nov 25, 2012 at 02:32 PM.
Reply With Quote