Thread: Discussion OSD not level - any ideas?
View Single Post
Old Nov 25, 2012, 02:39 AM
Efliernz is offline
Find More Posts by Efliernz
I'll fly anything...
Efliernz's Avatar
Hamilton, New Zealand
Joined Jan 2007
971 Posts
Discussion
OSD not level - any ideas?

I have not used the ODS in the past so I have nothing to compare this to.

I have flashed the latest firmware and started from the beginning with temp and the acc calibration process. I have done this twice, getting the same results. The horizon is not level... and it should be. It is level in the setup program.


Another thing I find strange is that I have centered all my TX trims and subtrims and started clean. My DW VM-6 (in manual mode) lifts up and is perfectly in trim. Magnificently perfect! When I switch to AL, I need a lot of roll trim to balance it - as though it is trying to balance to what the OSD tilt is. Yes I can trim it out (with a heap of trim), repower, all that stuff but I am wondering if others are seeing similar results when changing to the new firmware.

Pete
Efliernz is offline Find More Posts by Efliernz
Reply With Quote