: Build Log
"Sopwith Camel" #19 Free Flight to RC Flight Kitbash Contest >> RMCCOR7737
View Single Post
Nov 24, 2012
, 09:11 PM
United States, VA, Stafford
Joined Jun 2009
Finished up the sides of the fuse. Nothing special, just a few formers and 1/16" sheeting. I was gonna start building the cock pit on the frame when I realized I was not real sure how I was going to go about it. I also did not want to obstruct access to the fuse cavity as I am going to need to get the electronics and gigging in there. So I decided to build it on the table figuring if it comes out ok I would just attach it to the fuse. Turns out I may just decide to make it into a hatch. After all, you can never have too many access points.
View all Images in thread
Nice fit around wing....
Still needs cock pit area removed....
A little rough still. Will work on it some more later....