View Single Post
Old Nov 24, 2012, 03:14 PM
RickEis is offline
Find More Posts by RickEis
Registered User
United States, AZ, Prescott Valley
Joined Feb 2012
179 Posts
Quote:
Originally Posted by Dennis Frie View Post
Just checked, analog input 0 and 1, works as expected

Try with your multimeter and measure the voltage from the voltage-divider. It should be something like 3 volt.
On this schematic (see pict) - ( UNO NO NANO
I get 0.17V when measured from ground to pin 0.

You can see my voltage-divider
Ha - maybe I used wrong resistors - maybe my sensor is shot ?

Rick
RickEis is offline Find More Posts by RickEis
Reply With Quote