Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Nov 24, 2012, 11:46 AM
tom-tom 1 is offline
Find More Posts by tom-tom 1
Registered User
Joined Jun 2010
61 Posts
RCvertt
I built another board,up loaded the FT1.7 code to it and installed it into my QTR. The motors work (-1, bad ESC) but the ailerons and tilt don't. I got the code from this thread. The last one posted for F&T. PinA0 =left aileron,A1=right aileron, and A2=tilt.
I have the tilt in receiver channel 8-aux3. Aux 3 is mixed to activate flaps with 3 positions for the 3 tilt positions.

How do I get them to work. I do have power on the red and black wires to the servos.I have not tried to change anything in the code.
tom-tom 1 is offline Find More Posts by tom-tom 1
Reply With Quote