View Single Post
Old Nov 23, 2012, 05:08 PM
DanL is offline
Find More Posts by DanL
Registered User
DanL's Avatar
United States, MN, Brainerd
Joined Oct 2004
2,499 Posts
OK, just pulled all my servos, electronics ,etc friom the hull. Will start from scratch with sliding servos for slack control. Attached is s very prelim drawing based on fairly close dimensions.
The headsail servo will be very low . The main and fore servo drums will ride above the headsail drum. The main and fore servo drums will be on separate planes to allow slide-by clearance.
The driver servo will be mounted to the rear, very low and on its side. The arm will be vertical and swing to the side of the other sail drums.
Hope this works. Help/comments welcome.
DanL is offline Find More Posts by DanL
Reply With Quote