Thread: New Product CAT6 Servo Extension
View Single Post
Old Nov 23, 2012, 12:38 AM
KiwiNATOR is offline
Find More Posts by KiwiNATOR
Fetus Destroyer
KiwiNATOR's Avatar
United States, WA, Seattle
Joined Jul 2009
127 Posts
Could you explain a little how this works?

What happens to the servo PWM signal over a long run of CAT6 if I don't have these sending and receiving boards?

Is there a voltage drop on the receiving end if I don't use a BEC or battery?

So that jumper on the boards is for supplying power with a battery or BEC?

These boards boost the PWM signal?

Can I use one sending board, split the cat6 and use two receiving boards to control two pairs of servos?
KiwiNATOR is offline Find More Posts by KiwiNATOR
Last edited by KiwiNATOR; Nov 23, 2012 at 12:49 AM.
Reply With Quote