Thread: Discussion Fy-31ap
View Single Post
Old Nov 22, 2012, 09:16 PM
larry baraniuk is offline
Find More Posts by larry baraniuk
Registered User
Banff Alberta Canada
Joined Nov 2004
607 Posts
Quote:
Originally Posted by tupelo View Post
Could someone post an image with the FY-31AP powered with two separate BECs. One for the AP and one for the servos.

I would like to have this arrangement as I plan to mount the 31AP into a 1/4 scale Piper Cub and I am not sure a single BEC connected to the receiver can provide enough juice for both the servos and the AP.

Thanks!
The attached diagram shows my setup for using a separate BEC to power up the servos.
I am using the same colour coding as the FY -31 APs hookup to the receiver connections..I use coloured heat shrink to mark the wires.
Rather than using 3 servo extensions, I am using only 2 female servo connectors and 3 male servo connections mainly because I have a shortage of female connectors and an ample supply of male connectors.
larry baraniuk is offline Find More Posts by larry baraniuk
Reply With Quote