View Single Post
Old Nov 22, 2012, 06:22 PM
Taget is offline
Find More Posts by Taget
Registered User
Taget's Avatar
United States, MI, Marquette
Joined Dec 2010
208 Posts
Still getting the hang of this machine. Had the machine draw a few gears and a rough attempt at Mickey Mouse, at the kids request. The more i use it the more my comfort level increases.

Added home switches to my machine on all axis. One is a lever switch from Radioshack and the other 2 switches are reclaimed power switches from computer cases. Cheap fix but needed to add software debounce to make up for the low quality of the switch.

Who else is using LinuxCNC(emc2)? I am a big fan of open source software. I am really glad i found this thread, as i had never come across this machine until then.

Cheers
Taget is offline Find More Posts by Taget
Reply With Quote