Thread: Discussion IOM General Discussion
View Single Post
Old Nov 21, 2012, 10:41 PM
gpzy is offline
Find More Posts by gpzy
FROM THE MIND OF A MADMAN
gpzy's Avatar
United States, CA, Los Angeles
Joined Apr 2007
3,425 Posts
Quote:
Originally Posted by jims123 View Post
Ok.. The pots back in and sealed..but I didn't use the polyurethane goop cause its so strong I worried I'd have a very hard time removing it if needed later, so used Elmer's glue in a I inch wide seal around ( after clearing all the original silicone) the top and will retest it once its dry. I'm on to doing the rudder to fit the hull contour tomorrow. Agree the IOM world races are a lot more interesting than my US450 saga..
Is Elmers glue water proof ?
gpzy is offline Find More Posts by gpzy
Reply With Quote