View Single Post
Old Nov 20, 2012, 03:17 PM
RickEis is offline
Find More Posts by RickEis
Registered User
United States, AZ, Prescott Valley
Joined Feb 2012
179 Posts
Quote:
Originally Posted by Dennis Frie View Post
10K pull-up resistor is the "normal" thing to do with reset-pins etc. but as the direct connection to Vcc is recommended in the datasheet, I would be surprised it that's the problem.

Nevertheless - it's worth a try
OK - hooked it up as in the last schematic - started with a good video - then I inserted our project - no difference - I did note that when only the output to the screen was connected the screen went from no signal to a gray screen when connected - then when I hook up the camera the screen shows what the camera see's - no OSD yet ?
RickEis is offline Find More Posts by RickEis
Reply With Quote