View Single Post
Old Nov 20, 2012, 02:53 PM
Dennis Frie is offline
Find More Posts by Dennis Frie
Just another user
Dennis Frie's Avatar
Denmark, Capital Region of Denmark, Naerum
Joined Feb 2011
1,362 Posts
Quote:
Originally Posted by thnilsen View Post
One thing to try out is to use a 10kOhm pullup resistor between 5V and the RESET pin. This is something I picked up from the Aeroquad forum which uses the same board for OSD. WIthout it the MAX board keeps resetting.

If you can't get it working, lI can try to dig out some of the old code I have laying about for arduino. Its been over a year since I played with the MAX board, but it shouldn't be that difficult to get a picture from it when hooked up to the DUE.

- Thomas
10K pull-up resistor is the "normal" thing to do with reset-pins etc. but as the direct connection to Vcc is recommended in the datasheet, I would be surprised it that's the problem.

Nevertheless - it's worth a try
Dennis Frie is offline Find More Posts by Dennis Frie
Reply With Quote