Thread: Question CA glue
View Single Post
Old Nov 19, 2012, 06:51 PM
BMatthews is online now
Find More Posts by BMatthews
B for Bruce
BMatthews's Avatar
The 'Wack, BC, Canada
Joined Oct 2002
12,801 Posts
Use the little bit of teflon tube pushed down into the tip of the nozzle. Cut the teflon on a pretty long angle. The tip of the end will develop blobs due to picking up dust and such but you can pull that off. Meanwhile the long angle slanted opening generally stays clear.

It also helps if you let a drop form on the end of the tube and touch only the drop to the joint and let it wick away from contact with the tip of the tubing.

It's simply all about keeping the bottle and the end of the tube clean as possible. It also helps if you squeeze just a little BEFORE tipping it up so that there's some suction to draw the stuff in the tube back into the bottle rather than it continuing to bubble out of the tube eve after you set it down.
BMatthews is online now Find More Posts by BMatthews
Reply With Quote