View Single Post
Old Nov 19, 2012, 06:10 PM
Daedalus66 is online now
Find More Posts by Daedalus66
60 years of RC flying
Daedalus66's Avatar
Canada, ON, Ottawa
Joined Feb 2006
18,362 Posts
Quote:
Originally Posted by tech69x View Post
Hello all I just pulled the trigger on this for my 9x I was just wanted to know if it is as easy as they say
Thanks
It's very straight forward. One hint. Make sure the printed circuit board in the Tx is REALLY clean. Wash off any flux from the pads with isopropyl alcohol. And if the pads have bumps of solder on them, use solder wick to soak up the excess. It's crucial to get good contact.

Then follow the instructions carefully.
Daedalus66 is online now Find More Posts by Daedalus66
Reply With Quote