Thread: Article Sky Angel 50mm EDFs Review
View Single Post
Old Nov 19, 2012, 12:06 PM
Mike20 is offline
Find More Posts by Mike20
Registered User
Mike20's Avatar
Joined Sep 2012
544 Posts
Quote:
Originally Posted by mopetista View Post
now would you believe it most people find out (by accident or otherwise) how to get a plastic rotor with a 2mm to fit a threaded 3mm shaft - by enlarging the hole :-)

joking aside, I think the question was rather how to fit the 6-blade rotor to a Turnigy 2610 motor which has a 3mm - non-threaded - shaft. That is the motor you state you are using, not the stocker. I guess it has been asked before but I don't remember the answer...

cheers
Clemens
The turnigy 2610 motor comes with both 2.3mm and 3mm shafts. So I'm guessing he used the 2.3mm and that's why he had to ream out the hole to fit the shaft.
Mike20 is offline Find More Posts by Mike20
Reply With Quote