View Single Post
Old Nov 19, 2012, 08:19 AM
LittleMo is offline
Find More Posts by LittleMo
Registered User
LittleMo's Avatar
United States, VA
Joined Dec 2006
1,501 Posts
Why not just start with the MTC-01? It's using ATmega168's internally and has all the Cyprus RF chips ready to go. It must use some "other" communication method than PPM when plugged into the DSC port of the WK-2801 though because I haven't been able to get it to work in a regular TX with PPM output.

If you could figure out what protocol the WK-2801 is using (it's only using the standard mono PPM type cable) to talk to the cube then that would be a cheap and easy way to get Devo support on any TX.

The MTC-01 needs a better antenna than it comes with though and may be power limited (hack the firmware to increase power like the other Devo's?). Maybe some custom firmware would do the trick, like I said, it's just a couple ATmega's. Certainly easier and probably cheaper than building your own board that's just going to have the same components.
LittleMo is offline Find More Posts by LittleMo
Reply With Quote