View Single Post
Old Nov 19, 2012, 02:53 AM
Chris T is offline
Find More Posts by Chris T
Micro Jet Pilot
Chris T's Avatar
Joined Jul 2005
2,091 Posts
Joe do you mean 2p or 2s? 2s wouldn't be very suitable in my eyes. The servos/actuators should run on full supply voltage not on BEC. Also a lot more parts would be reqired to handle 2s I think. 2p is of course the same as 1p.

Since the DT rx can handle up to 10V, I assume there is a BEC LDO on it and it will provide 5V to the servos. You could plug a motor this 5V supply, but then would have big losses due to the voltage drop in the LDO. I am not even sure if this is how the DT rx works, but this is not a good option anyway. I'd say get it layed out for 1S xP.

Chris
Chris T is offline Find More Posts by Chris T
Last edited by Chris T; Nov 19, 2012 at 03:26 AM.
Reply With Quote